fbpx

How to setup or connect Smart Bro to a router?

If you are subscribed to the Smart Bro Plan 999, you can still connect or configure it to a router so you can share the internet connection to other WiFi devices in your house. See the step by step instructions below to setup Smart Bro with your WiFi router.

How to Configure Smart Bro with a Router:

Step 1. First you must connect the Ethernet cable from the smartbro antenna to the WAN/Internet port of the router.

Step 2. Connect your computer to one of the Ethernet ports of the router.

Step 3. Make sure that ur PC is set to Dynamic IP (Obtain IP automatically)

Step 4. On your Internet browser, type 192.168.1.1, leave username blank and password admin.

Step 5. On the router’s setup page, set the Internet connection type to Automatic Configuration (DHCP) or Obtain an IP Automatically.

Step 6. Save the settings.

Step 7. Check the Status Tab to check if the router was able to get the connection from SmartBro.

Step 8. If Automatic Configuration (DHCP) didnt work, set the router to Static IP. Take note of the IP address, subnet mask, default gateway, DNS 1 and 2 of your PC when its connected directly to SmartBro, then put it on the corresponding fields.

Subscribe to Blog via Email

Enter your email address to subscribe to this blog and receive notifications of new posts by email.

Join 984 other subscribers

86 Responses

  1. Avatar for mywifiext.net mywifiext.net says:

    How do I log in to my NETGEAR WiFi Range Extender Setup?
    1. Launch a web browser from a computer or mobile device that is connected to your extender’s network.
    2. If your Netgear extender and router use different WiFi network names (SSIDs), type www.mywifiext.net into the address field of your web browser.
    3. Click or tap Enter.

  2. Avatar for Jack Jack says:

    To log in to the TP-Link router and access the admin panel http://tplinkwifi.net is used. It is the web-based control panel for all TP-Link routers. In order to log in to the admin panel, you require the IP address, username, and password of the router as well. After logging in, you’ll be able to configure the router accordingly.

Leave a Reply
JOIN OUR TELEGRAM DISCUSSION

Your email address will not be published. Required fields are marked *