web analytics

How to setup or connect Smart Bro to a router?

If you are subscribed to the Smart Bro Plan 999, you can still connect or configure it to a router so you can share the internet connection to other WiFi devices in your house. See the step by step instructions below to setup Smart Bro with your WiFi router.

How to Configure Smart Bro with a Router:

Step 1. First you must connect the Ethernet cable from the smartbro antenna to the WAN/Internet port of the router.

Step 2. Connect your computer to one of the Ethernet ports of the router.

Step 3. Make sure that ur PC is set to Dynamic IP (Obtain IP automatically)

Step 4. On your Internet browser, type, leave username blank and password admin.

Step 5. On the router’s setup page, set the Internet connection type to Automatic Configuration (DHCP) or Obtain an IP Automatically.

Step 6. Save the settings.

Step 7. Check the Status Tab to check if the router was able to get the connection from SmartBro.

Step 8. If Automatic Configuration (DHCP) didnt work, set the router to Static IP. Take note of the IP address, subnet mask, default gateway, DNS 1 and 2 of your PC when its connected directly to SmartBro, then put it on the corresponding fields.

You may also like...

48 Responses

  1. justin says:

    when i enter the my browser keep on saying error 504. so i tried looking in the command prompt and got this it worked but when i type the password and username i still get error in password and username everytime.

  2. jek says:

    you need to reset the router because it has been used previously, so you won’t be able to guess the password.

    the above data is for a new or unchanged password router.

  3. bobforrester says:

    wich are the dns1 and dns2 for reaching the provider smart bro through my router linksys ?

  4. Lady_Deathstrike21 says:

    Hello! thanks for the help! I have been trying to connect my Smart Bro through a router for a little more than three months but I couldn’t that I almost lost my patience. And when I found your site, I followed you instructions and finally, FINALLY, I have a wifi connection. Thanks a lot! :-)

  5. ederfonorem says:


    This is a speedtest result of my 4G ROCKET WIFI PLUS ng Smartbro 0.58Mbps out of the publicly promised 20.0 Mbps!!! It’s been more than 1 month now since April 4 that Smartbro received by complaint on slow connection. But that F_____G company is not doing anything!!! Can anyone from the National Telecommunications Commission (c/o Secretary Mar Roxas) be sensitive enough to check the Smartbro’s HONESTY in terms of advertising 20.0Mbps but delivering to its customer a turtle-speed of 0.58Mbps or 2.9% ONLY of what this F_____G Smartbro advertises?

  6. ma. elizabeth erana says:

    how can we reconnect our internet connection? we already paid, then its been connected but we cannot connect to the server…. what should we do?

  7. ZeroDanger says:

    Paano kung di mabukas ang paulit u;it na nmn ginawa aya pa mabukas

    • R2 says:

      try the reset button of the router, gamit ka lang paper clip to push the small button somewhere on the side of the router.

  8. DarkShadows says:

    Our router is Linksys e1500. I followed the instructions but it didnt work. Does it need a different setup or do i have to reinstall the router? Thanks.

  9. Renan says:

    Anyone here knows how to reconnect smart bro plan999, pls i need help to reconnect it because we just shifted to our new house.I am just a two month subscribed to this and it will be costly to pay P1450 to smart just to get internet connection.btw everything has been set-up already including the router, my only problem was that we dont have internet connection and it asks for log in id and password.any help would be very much appreciated.thanks.

  10. juzz says:

    @zte, I’m trying to setup asus RT N13u B1 to my smartbro internet and only the pc has internet and no wifi detected. when I try to setup a static ip and copied the pc ip, subnet, default gateway is says “255.xxx.xxx.x is not a valid ip address” need your help.

  11. ewOx says:

    anyone here knows if there is a dsl to ethernet adpater converter? just got my modem+wifi router from a friend. i was planning to set it up to my smartbro. my problem ryt now is that the WAN/Internet port is a DSL port. i cant connect the ethernet cable from the canopy antenna of smartbro.

  12. doodlesurf says: for Sun Broadband Wireless Modem Log in Page.

  13. anthony bantugan says:

    sir yung connection namin smartbro. iinstallan sana namin ng router linksys e900.. nainstalled na namin pero wala siyang internet nadedetect nadin ng cp na may wifi. okay naman din yung signal niya.. wala lang siyang internet.. ano ba dapat gawin sir?
    wala kasi kaming modem sir..

  14. Gracee says:


    Can you please help me out? I have brought a wifi router to my family so that they can connect all gadgets at home, (PANDI, BULACAN) However, whenever they connect the router, they have to go thru the same set-up (Name, REF, ACCOUNT NO. etc) online – WHY? My family gave up already and stop using the router, but it is not the router that has a problem since we setup everything at my home (MAKATI)

    What seems to be the problem? Is it SMART BRO? Only one gadget can be connected on WIFI, if they tried to connect another one, they have to go to fillup all the form online again! Hassle!

  15. Giankoi says:

    Hi po magandang gabi mga master, yung dmsrtbro wifi router ko po if I turn on po tapos mga one minute it will automatically turn off po. bigla pong na tuturn off.. sana po matulungan niyo ako ..

  16. Greetings! Very helpful advice in this particular article! It
    is the little changes that produce the most important changes.
    Many thanks for sharing!

  17. mario melendres says:

    my smart bro router is working but the signal at the second floor of the house is weak. How can I
    boost the signal?

  18. Hi there, I desire to subscribe for this blog to obtain most up-to-date updates, therefore where can i do
    it please assist.

  19. jomar says:

    I have this CDR King wifi router and configured it, my devices can connect but cannot browse the internet. It says that there is a problem with the network. need help please.

  20. raymor says:

    It just started a couple of days, before it was really okay, but now.. with wifi signal but can’t browse the internet.. only work if you directly plug the connection to a pc.. can’t use my wifi router.

  21. mrahc says:

    I just bought a router then pagkauwi ko sinet up ko na sya, nakaconnect naman sya kasi may lights? pero sabi niya no internet connection. helpppp

  22. don says:

    ano po yong default username at password ng smartbro wifi ung dating canopy pa?

  23. devin says:

    tanong ko lang po bakit hindi maka connect ang iphone sa wifi ng smart bro? may solusyon po ba kau jan ? :)

  24. lanie says:

    bka po matulungan nyo ako ung router ko naconnect ko na sa smart bro conopy kaso isa lng pwd gumamit kc lumalabas ung customer portal nya anu po ba dapat kong gawin para ma wla ung customer portal sayang kc binabayad ko 500 kada install sa router tapos 500 din ung router 6moths plang sira na agad router ko masyadong magastos kung laging ganyan
    salamat po

  25. Samiul says:

    Thanks for the instructions.

  26. jhon says:

    To set up or connect smart bro to the router follow these steps:
    a) Open the browser
    b) Type the IP address that provided on the manual enter button
    c) Type the password
    d) Click to the login
    e) Select your network connection
    f) Choose the internet and connect it
    how to change Netgear password

  27. Klein says:

    Hi yung LTE smartbro Evoluzn Po namin nawalan Ng signal. Red lang sya, kahit May load yung simcard. Almost a month na po. What do I need to do po? Badly needed your advice. Thanks po.

  28. This is really a thing to consider, thank you very much regarding writing about this subject. . !

  29. If you are subscribed to the Smart Bro Plan 999, you can still connect or configure it to a router so you can share the internet connection to other WiFi devices in your house. See the step by step instructions below to setup Smart Bro with your WiFi router.

  30. thanks for sharing this useful info regarding router setup it was very helpful

  31. This is really a thing to consider, thank you very much regarding writing about this subject

  32. mywifiext says:

    looking for netgear extender setup guide and netgear_ext? check out step-by-step instructions to complete new extender setup or call +1 866-606-3055 for more quries…

  33. Great!
    Check out the Wifi Range Extender Setup Page providing the details regarding New Extender Setup.

  34. http://netgearwifiextendersetup.com/
    Netgear wifi extender Setup provide high speed internet connection in the dead spots of your local area.

  35. Facing issues while accessing mywifiext net login web page? We are here with a fix. Check your Netgear extender connectivity to the router.

  36. Thanks for sharing this useful information. keep posting

  37. Thanks for sharing this useful column

  38. jameswoods says:

    Thanks for sharing this amazing post

  39. ap.setup says:

    Ap. Setup is an offline website that you will be able to use only when you are connected to your Wavlink Extender Setup page. So, it doesn’t matter if you have a repeater, a modem, an outdoor access point, and so on, all you have to do is connect to the network and then access the login tab.

  40. mywifiext says:

    In the dead spots of your local area, Netgear wifi extender Setup offers high-speed internet access.Netgear extender setup

  41. Mywifiext says:

    In case you are having the issues with the extender setups then there is no need to worry because mywifiext.net is always there to provide you with the top-notch solutions in this particular field. We also have the best professional team who will solve all your queries very efficiently. You can contact us on our toll-free number 1-804-999-8779 to solve all your issues.

  42. mywifiext is local path to open genie setup configuration .When the user accesses this mywifiext.net on the web browser to set up a wireless adapter ,it shows an error message due to complications or is unable to compare to the domain
    or visit website : http://mynewextsetup.us/

Leave a Reply

Your email address will not be published. Required fields are marked *